Your shopping cart is empty!
Your shopping cart is empty!
Manufacturer: Cisco Systems, Inc Manufacturer Part Number: PWR-2650-AC= Brand Name: Cisco Product Name: 2600 Series Router AC Power Supply Product Type: Proprietary Power Supply Input Voltage Type: AC Input Voltage: 240 V AC Input Voltage Range: 100 V AC to 240 V AC Frequency: 50 Hz to 60 Hz Output Power: 72 W Compatibility: Cisco 2600 Series Router..
Single-port, four-wire, WIC-1DSU-56K4 card combines a DSU/CSU into a single card with 64-kbps maximum throughput speed. DSU/CSU interface devices are always required to interface between the synchronous serial ports of a router and the telco/Post, Telephone, and Telegraph (PTT)-supplied data communications circuit. A DSU is a device used in digital transmission for connecting data terminal equipment to a digital transmission service. A CSU is a digital interface device that connects end-user equipment to a ..
This module provides a single auto-sensing 10/100BaseTX connection via an RJ-45 connector and two channelized T1/ISDN PRI with integrated DSU/CSU connections via RJ-48 connectors.ISDN Concentration , Inter-VLAN Routing LAN-to-LAN Routing Serial & Legacy Concentration VPN & Firewall Solutions Token Ring ISL is supported in Cisco IOS Version 12.0(3)T Does not support a Fast Ethernet channel Each Wan port is configured independently (one port for ISDN and the other for channelized T1). The default duplex mod..
The Cisco® IP Communications voice/fax network modules provide enterprises, managed service providers, and service providers the ability to directly connect the public switched telephone network (PSTN) and traditional telephony equipment (private branch exchange [PBX], key system, analog telephones, fax machines, etc.) to Cisco 2600XM and 2800 Series, Cisco 2691, 3640, and 3660, and Cisco 3700 and 3800 Series voice gateway routers. This set of Cisco IP Communications voice/fax network modules delivers the m..
This network module has 2 WAN Interface Card (WIC) expansion slots, supporting all current WICs and VWICs.Modular Router Solutions: Serial & Legacy Concentration, ISDN Concentration Protocols supported:, Full Cisco IOS software as of 12.0(7)XK WIC Performance:, Up to 8Mb/s per WIC (with just 1 WIC installed) The Maximum Number of NMs that can be utilized in each of the 2600/3600 families is as follows:, 2600: 1, 2691: 1, 3620: 1, 3640: 3, 3660: 6, 3725: 2, 3745: 4 Comments:, No reliance on other network m..
The 32-port asynchronous serial network module supports 32 asynchronous serial interfaces at speeds up to 134 kbps. The 32 ports are cabled with four custom "octopus" cables, each terminating in 8 ports, each with an option of physical endpoints, including RJ-45 and DB-25 connectors.Product Type: Network Module Application/Usage: Data Networking Interfaces/Ports: 32 x Asynchronous Serial WAN Interfaces/Ports Details: 4 x HD-68 Connector, 32 x Port Asynchronous Serial Compatibility: Supported Platforms & M..
The asynchronous/synchronous serial network module NM-4A/S provides flexible multi-protocol support, with each port individually configurable in synchronous or asynchronous mode, offering mixed-media dial support in a single chassis. Applications for Asynchronous/Synchronous support include: · Low speed WAN aggregation (up to 128 Kbps) · Dial-up modem support · Async or Sync connections to management ports of other equipment · Transport of legacy protocols such as Bi-sync and SDLC..
The Cisco Integrated V.92 Analog Modem Network Modules provide Cost-effective analog telephone service Connectivity for lower-density Remote-access service (RAS), dial-out and Fax-out modem access, asynchronous Dial-on-demand routing (DDR) plus dial Backup, and remote router management. Combined with the differentiated services Delivered through Cisco IOS Software, Cisco 2600 Series, 3660, and 3700 series Routers offer customers best-in-class Scalability, flexibility, and investment Protection, all in cost-..
The asynchronous/synchronous serial network module NM-8A/S provides flexible multi-protocol support, with each port individually configurable in synchronous or asynchronous mode, offering mixed-media dial support in a single chassis. Applications for Asynchronous/Synchronous support include: · Low speed WAN aggregation (up to 128 Kbps) · Dial-up modem support · Async or Sync connections to management ports of other equipment · Transport of legacy protocols such as Bi-sync and SDLC..
This voice/fax module provides two T1 connections with drop and insert and support for 48 channels of medium complexity voice compression using any of the following VoCoders; G.711, G.729a/b, G.726, and fax. This module can also be used to provide 24 channels of high and/or medium complexity voice compression split between the two T1 ports using any of all of the following VoCoders; G.711, G.729, G.729a/b, G.726, G.728, G.723.1, and fax. The NM-HDV-2T1-48 consists of a network module, voice interface card, ..
Content Engine Network Module with 20GB hard disk.Manufacturer: Cisco Systems, Inc Manufacturer Part Number: NM-CE-BP-20G-K9= Brand Name: Cisco Product Model: NM-CE-BP-80G-S-K9 Product Name: Content Engine Network Module Product Type: Network Module Application/Usage: Data Networking Interfaces/Ports: 1 x 100Base-TX Interfaces/Ports Details: 1 x RJ-45 100Base-TX Connectivity Media: Category 5 or higher UTP Data Transfer Rate: 100 Mbps Fast Ethernet Compatibility: Supported Platforms & Minimum IOS Versions..
This network module is the carrier card for the PVDM-12 and VWIC cards (it is the basis for all six NM-HDV voice bundles) to build custom configurations. Up to 30 unique combinations of network module, DSP modules, and VWICs exist, allowing users to increase voice channel support from as little as 6 voice/fax channels up to 60 voice/fax channels.Manufacturer: Cisco Systems, Inc Manufacturer Part Number: NM-HDV= Brand Name: Cisco Product Model: NM-HDA-4FXS Product Name: Voice/Fax Network Module Product Typ..
The NM-1HSSI is a single port, high-speed network module that provides connectivity to a Wide Area Network. Demand for high capacity corporate backbones, high-speed Internet access, Virtual Private Networks (VPNs), and trunking connections for service provider internetworking has led to an increase demand for clear channel DS3 and E3 connections. Also see the NM-1T3/E3 clear channel T3/E3 Network Module. The NM-1HSSI Network Module supports speeds up to 52 Mbps. The NM-1HSSI also supports fractional T3/E3..
One-port ISDN WAN Interface CardThe 1-port ISDN BRI WAN interface card offers a single ISDN BRI connection via an RJ-45 connector. It requires an external NT-1 device for connection to the WAN This interface card inserts into a Cisco mixed-media network module or directly into a Cisco WAN Interface Card (WIC) expansion slot.Product Type: WAN Interface Card (WIC) Application/Usage: Wide Area Network Interfaces/Ports: 1 x ISDN BRI (S/T) Interfaces/Ports Details: 1 x RJ-45 ISDN BRI (S/T) Compatibility: Thi..
The 4- and 8-port ISDN BRI network modules provide various port densities for ISDN BRI connectivity. The optional, integrated NT1 allows consolidated customer premises equipment (CPE) to provide multifunction dial access server, router, and other capabilities within power branch office environments.Four versions of ISDN BRI network modules are available. Each 4- and 8-port module has the option of an S/T interface or an onboard NT1 for each port. Local static RAM (SRAM) is used for buffer descriptors and..
The 8-port ISDN BRI with integrated NT-1 network module provides eight ISDN BRI connections via RJ-45 connectors.Modular Router Solutions: ISDN Concentration, LAN-to-LAN Routing Number of Modules per Chassis:, Cisco 3640: 3, Cisco 3620: 1, Cisco 2600: 1 Protocols Supported:, Full Cisco IOS support in Release 11.2 and 11.3 Comments:, No reliance on other network modules, WAN interface cards, voice interface cards, or advanced integration modulesManufacturer: Cisco Systems, Inc Manufacturer Part Number: N..
Content acceleration and delivery enhance user productivity while optimizing WAN bandwidth. The Cisco Content Engine Network Modules combine the advanced content acceleration features of the Cisco Content Engine 500 Series with the Cisco 2600, 3600, and 3700 series into one easy-to-manage content networking solution. Cisco's Content Engine Network Modules for the Cisco 2600, 3600, and 3700 series routers offer the industrys first and only router-integrated content-delivery system...
The Cisco® High-Density Packet Voice Digital Signal Processor (DSP) Module (PVDM2) enables Cisco Integrated Services Routers to provide high-density voice connectivity, conferencing, and transcoding capabilities in Cisco IP Communications solutions. Cisco Integrated Services Routers provide enterprises and service providers with a toll bypass solution by connecting their existing telephony equipment (such as private branch exchanges [PBXs], key systems, analog telephones, and fax machines) to a toll-free da..
Manufacturer: Cisco Systems, Inc Manufacturer Part Number: MEM2600XM-32FS= Brand Name: Cisco Product Name: 32MB Flash Memory Packaged Quantity: 1 Product Type: Flash Memory Memory Size: 32 MB Form Factor: 80-pin Compatibility: Cisco Router 2600XM Series: 2610XM, 2611XM, 2620XM, 2621XM, 2650XM, 2651XM..